Panasonic NN46240-501 - Manual (Page 215)

12 Patch management
Nortel Secure Router 8000 Series
Configuration Guide - Basic Configuration
common patch number
current patch number
running patch number
active patch number
patch area length
patch area start address
The patch information:
0
0
0
0
0x100000
0x100000
The value of the bold items in the preceding output is 0. This indicates that no patch is
running in the current system.
12.3 Uploading a patch
12.3.1 Establishing the configuration task
Applicable environment
Before you install a patch, upload the patch to the root directory of the flash memory of the
master RPU. Then, copy the patch to the root directory of the flash memory of the slave RPU.
You can use the following methods to upload a patch: FTP, TFTP, and Xmodem.
Preconfiguration tasks
Before you upload a patch, complete the following tasks:
• Ensure that the router starts normally after it is powered on.
• Ensure that you can log on to the router.
Data preparation
Before you run a patch, you need to obtain a patch that is consistent with the board.
Configuration procedures
No. Procedure
1 Uploading a patch to the root directory of the flash of the master RPU
2 Copying a patch to the root directory of the flash of the slave RPU
12.3.2 Uploading a patch to the root directory of the flash of the
master RPU
Upload a patch to the root directory of the flash memory of the master RPU.
The Secure Router 8000 Series supports uploading files through FTP, TFTP, and Xmodem.
Choose the uploading method based on your requirements.
12-4 Nortel Networks Inc. Issue 5.3 (30 March 2009)