2 example of logging on through telnet, Networking requirements, Configuration roadmap – Panasonic NN46240-501 User Manual
Page 57: Data preparation, Configuration procedure, 2 example of logging on through telnet -10
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
2 Configuration environment setup
Nortel Secure Router 8000 Series
Configuration Guide - Basic Configuration
Enter the command to check the running status of the router or configure the router, or enter ?
for help.
For more information, see the following chapters in this document.
—End
2.5.2 Example of logging on through Telnet
Networking requirements
You can log on to the router on other network segments through the PC or other terminals to
perform remote maintenance.
Figure 2-5 Establishing the configuration environment through the wide area network (WAN)
GE1/0/0
202.38.160.92/16,^^
PC
Router
Target
Router
Configuration roadmap
•
Establish the physical connection.
•
Configure user logon parameters.
•
Log on to the router from the client side.
Data preparation
•
IP address of the PC
•
IP address of the Ethernet interface on the router
•
user information accessed through Telnet (including the user name, password, and
authentication mode)
Configuration procedure
Step 1 Connect the PC and the router respectively to the network.
Step 2 Configure logon user parameters.
• Configure the logon address:
< N o r t e l >
system-view
[ N o r t e l ]
interface GigabitEthernet 1/0/0
[ N o r t e l - G i g a b i t E t h e r n e t 1 / 0 / 0 ]
ip address 202.38.160.92 255.255.0.0
[ N o r t e l - G i g a b i t E t h e r n e t 1 / 0 / 0 ]
quit
• Configure the logon authentication mode:
[ N o r t e l ]
aaa
2-10
Nortel Networks Inc.
Issue 5.3 (30 March 2009)