Panasonic NN46240-501 - Manual (Page 50)

Nortel Secure Router 8000 Series
Configuration Guide - Basic Configuration 2 Configuration environment setup
Où NOTE
If you modify the IP address of the router when you configure the router through Telnet, the
modification can disconnect Telnet. If necessary, set up the connection again after you enter a new IP
address.
2.1.3 AUX port configuration
Applicable environment
You can configure the router by remote logon.
Applications
If you cannot configure the router by local logon and no reachable route to other routers exists,
connect the PC and the router through the Public Switched Telephone Network (PSTN).
Pre-enable the modem dial-up of the AUX port through the console port and configure the
user name and password.
2.2 Establishing the local configuration environment
through the console port
2.2.1 Establishing the configuration task
Applicable environment
If you log in to the router for the first time or perform the local configuration, you need to log
in to the router through the Console port.
Preconfiguration tasks
Before you configure the router through the console port, complete the following tasks:
• Prepare the PC/terminal (including the serial port and RS-232 cable).
• Install a terminal emulation program on the PC (such as Windows XP HyperTerminal).
Data preparation
To configure the router, you need the following data.
No. Data
Terminal communication parameters (including baud rate, data bit, parity, stop
bit, and flow control)
Issue 5.3 (30 March 2009) Nortel Networks Inc. 2-3
1