Panasonic NN46240-501 - Manual (Page 58)

Nortel Secure Router 8000 Series
Configuration Guide - Basic Configuration 2 Configuration environment setup
[ N o r t e l - a a a ] local-user nortel password cipher test2
[ N o r t e l - a a a ] local-user nortel service-type telnet
[ N o r t e l - a a a ] local-user nortel level 3
[ N o r t e l - a a a ] quit
[ N o r t e l ] user-interface vty 0 4
[ N o r t e l - u i - v t y 0 - 1 4 ] authentication-mode aaa
Step 3 Configure the client logging on to the router.
Run Telnet on the PC, as shown in Figure 2-6.
Figure 2-6 Running the Telnet program on the PC
Step 4 Click OK.
In the logon window, enter the user name and password. After authentication, a command line
prompt such as
N o r t e l
appears. Enter the configuration environment in the user view.
—End
2.5.3 Example of logging on through the AUX port
Networking requirements
If you cannot configure the router by local logon and no reachable route to other routers exists,
connect the serial port of the PC and the AUX port of the router through the modem. The
detailed configuration environment is shown in Figure 2-7.
Figure 2-7 Establishing the remote configuration environment
Router
PC
Issue 5.3 (30 March 2009) Nortel Networks Inc. 2-11