Holtgreven GSE-375 User Manual
Page 23
17
When accessing a parameter, the parameter number appears briefly. The display then toggles between
the parameter name and selection. Pressing [UNITS] will again briefly display the parameter number.
To access a specific parameter (for example P200) (Model 370):
1. Press
[PRINT] four times to select the first digit.
DISPLAY READS 2
2. Press
[UNITS] to advance to the next digit.
DISPLAY READS 2.
3. Press
[PRINT] once to select the next digit.
DISPLAY READS 20
4. Press
[UNITS] to advance to the next digit.
DISPLAY READS 20.
5. Press
[PRINT] once to select the next digit.
DISPLAY READS 200
6. Press
[SELECT] to advance to the parameter.
DISPLAY READS P200.00 ~ Baud ~ 9600
To access a specific parameter (for example P200) (Model 375):
1. Key
in
200 [SELECT]
DISPLAY READS P200.00 ~ Baud ~ 9600
C
C
h
h
a
a
n
n
g
g
i
i
n
n
g
g
a
a
P
P
a
a
r
r
a
a
m
m
e
e
t
t
e
e
r
r
V
V
a
a
l
l
u
u
e
e
S
ELECTION
P
ARAMETERS
Selection parameters have a pre-defined list of choices to pick from. Each choice is numbered
and corresponds to a certain value. The choice number is shown to the right of the decimal point
within the parameter number. Repeatedly pressing [TARE] (Model 370) or [SAMPLE/Enter]
(Model 375) while viewing a selection parameter cycles through the available choices, or you can
key in the choice number.
P 200.00
Indicates Parameter
Parameter Number
Choice Number
For example, parameter 200 (P200) is a selection parameter that holds the baud rate for the
serial port. This is a selection parameter because a choice number between 00 and 12 must be
used. Each choice number corresponds to a different baud rate. To change the baud rate from
the default value of 9600 to 4800, perform the following steps from the Setup Mode.
To change the baud rate from the default value of 9600 to 4800:
1. Key
in
200 [SELECT]
DISPLAY READS P200.00 ~ Baud ~ 9600
2. Press
[TARE] (Model 370) or [SAMPLE/Enter] (Model 375) once.
DISPLAY READS P200.01 ~ Baud ~ 4800