Holtgreven GSE-375 User Manual
Page 58
52
T
T
i
i
m
m
e
e
a
a
n
n
d
d
D
D
a
a
t
t
e
e
S
S
e
e
t
t
u
u
p
p
(
(
M
M
o
o
d
d
e
e
l
l
3
3
7
7
0
0
)
)
The time and date feature is stored as non-volatile (time/date setting will not be lost when the unit
power is reset). The time/date parameter is available in the first two fixed transmits (See Transmit
Selection on page 29) and can be included in a custom transmit (See Custom Transmit Setup on
page 31).
The time and date can be accessed from the weigh mode with the [SELECT] key if P502 is
enabled. Also 11%s can be sent into the comm port to access the time/date entry regardless of
P502.
The time and date can be entered in the setup mode at P500 and P501. Access P500 to change
the time or P501 to change the date. To access the setup mode see page 15. Use the
instructions below to enter the time and/or date. Refer to page 19 to save the time and date and
exit to the weigh mode.
To enter the date in the setup mode or weigh mode
EXAMPLE: 01.09.04 (January 9, 2004)
1. Press
[PRINT] to toggle through the numbers to enter the month.
DISPLAY READS 1
2. Press
[UNITS] twice to move the decimal point over to separate the month from the day. It is
not necessary to enter a 0 before a single digit month. If it is a double-digit entry, press
[UNITS] once to move the cursor and then [PRINT] to scroll through the digits.
DISPLAY READS 1.
3. Press
[PRINT] to toggle through the numbers to enter the day.
DISPLAY READS 1.9
4. Press
[UNITS] twice to move the decimal point over to separate the day from the year. It is
not necessary to enter a 0 before a single digit month. If it is a double-digit entry, press
[UNITS] once to move the cursor and then [PRINT] to scroll through the digits.
DISPLAY READS 1.9.
5. Press
[PRINT] to toggle through the numbers to enter the year.
DISPLAY READS 1.9.0
6. Press
[UNITS] once to move the cursor and then press [PRINT] to scroll through the digits.
DISPLAY READS 1.9.04
7. Press
[TARE] twice to accept the entry.
DISPLAY READS 01.09.04
To enter the time in the setup mode or weigh mode
EXAMPLE: 16.32.41 (4:32:41 P.M.)
1. Press
[PRINT] to toggle through the numbers to enter the hour. Hours must be entered as
military time.
DISPLAY READS 1
2. Press
[UNITS] once to move the cursor. Press [PRINT] to select the next digit.
DISPLAY READS 16
3. Press
[UNITS] twice to move the decimal point over to separate the hour from the minutes. It
is not necessary to enter a 0 before a single digit hour.
DISPLAY READS 16.
4. Press
[PRINT] to toggle through the numbers to enter the minutes.