Holtgreven GSE-375 User Manual
Page 59
53
DISPLAY READS 16.3
5. Press
[UNITS] once to move the cursor. Press [PRINT] to select the next digit.
DISPLAY READS 16.32
6. Press
[UNITS] twice to move the decimal point over to separate the minutes from the
seconds.
DISPLAY READS 16.32.
7. Press
[PRINT] to toggle through the numbers to enter the seconds. The seconds do not have
to be entered. Press [TARE] to bypass entering the seconds.
DISPLAY READS 16.32.4
8. Press
[UNITS] once to move the cursor. Press [PRINT] to select the next digit.
DISPLAY READS 16.32.41
9. Press
[TARE] twice to accept the time entry. The date and time are now saved until power to
the Model 370/375 is lost. The display will be returned to the weigh mode.
DISPLAY READS 0.00
T
T
i
i
m
m
e
e
a
a
n
n
d
d
D
D
a
a
t
t
e
e
S
S
e
e
t
t
u
u
p
p
(
(
M
M
o
o
d
d
e
e
l
l
3
3
7
7
5
5
)
)
The time and date feature is stored as non-volatile (time/date setting will not be lost when the unit
power is reset). The time/date parameter is available in the first two fixed transmits (See Transmit
Selection on page 29) and can be included in a custom transmit (See Custom Transmit Setup on
page 31).
The time and date can be accessed from the weigh mode with the [SELECT] key if P502 is
enabled. Also 11%s can be sent into the comm port to access the time/date entry or 11
[SELECT] from the weigh mode.
The time and date can be entered in the same fashion as described below. Access P500 to
change the time or P501 to change the date. To access the setup mode see page 16.
To enter the date in the setup mode or weigh mode
EXAMPLE: 01.09.04 (January 9, 2004)
1. Key in the date in the following format: 1.9.4
DISPLAY READS 01.09.04
2. Press
[SAMPLE/Enter] to except the date and move to the time entry. Press
[SAMPLE/Enter] again to bypass the time entry.
To enter the time in the setup mode or weigh mode
EXAMPLE: 16.32.41 (4:32:41 P.M.)
1. Key in the date in the following format: 16.32.41
DISPLAY READS 16.32.41
2. Press
[SAMPLE/Enter] to except the time and move to the weigh mode.
U
U
p
p
g
g
r
r
a
a
d
d
e
e
M
M
o
o
d
d
e
e
l
l
3
3
7
7
0
0
/
/
3
3
7
7
5
5
F
F
i
i
r
r
m
m
w
w
a
a
r
r
e
e
The Model 370 and Model 375 have flash memory on the main board where the parameters are
stored. It is possible to update the firmware simply by using a computer. The firmware is loaded
into a flash memory IC. This allows for ease in loading firmware updates.