Holtgreven GSE-375 User Manual
Page 26
20
3. Press
[CLR] to exit without saving changes.
DISPLAY READS Enter ~ =Undo
4. Press
[SAMPLE/Enter] to undo changes.
DISPLAY READS Enter ~ =End
5. Press
[SAMPLE/Enter] to complete exit.
DISPLAY READS 0.00
F
F
a
a
c
c
t
t
o
o
r
r
y
y
D
D
e
e
f
f
a
a
u
u
l
l
t
t
Parameter 65001 and 65002 are available to return the Model 370/375 to factory settings.
Parameter 65001 will reset parameters including the calibration, while parameter 65002 resets all
parameters except the calibration.
After a factory default is performed and saved the Model 370/375 will be in the Quantity mode.
The display will show ‘do APS’ which means an average piece weight needs to be established.
Either perform a sample (refer to page 50) or press [SELECT] to chose another mode.
Return to factory default (370):
1. Access the setup mode. See page 15.
2. Key
in
65001 or 65002 [SELECT]
DISPLAY READS P65002~default-Cal
3. Press
[TARE] once.
DISPLAY READS Are U sure?~default=Enter
4. Press
[TARE] once.
DISPLAY READS Setup done~P65002~default-Cal
5. Press
[ZERO] [ZERO] [TARE] [TARE]
DISPLAY READS do APS
Return to factory default (375):
1. Access the setup mode. See page 15.
2. Key
in
65001 or 65002 [SELECT]
DISPLAY READS P65002~default-Cal
3. Press
[SAMPLE/Enter] once.
DISPLAY READS Are U sure?~default=Enter
4. Press
[SAMPLE/Enter] once.
DISPLAY READS Setup done~P65002~default-Cal
5. Press
[ZERO] [CLR] [SAMPLE/Enter] [SAMPLE/Enter]
DISPLAY READS do APS
L
L
i
i
s
s
t
t
o
o
f
f
P
P
a
a
r
r
a
a
m
m
e
e
t
t
e
e
r
r
s
s
The Model 370 and Model 375 have several parameters that can be configured to your specific
application. Table 3-1 is a complete list of the available parameters. Also refer to page 23
for
explanations of each parameter. The parameters shaded in gray do not apply to the Model
370/375.