KEYENCE BL-600 Series - Manual (Page 109)

99
Chapter 6 Functions for Reading Operation
6
* To check the reading rate on a PC screen, connect the BL-600 Series to a
PC and use the [[Monitor]] screen of the setup software.
➮ See page 62.
5. Quit the test mode.
Press the TEST switch again to quit the test mode. The STABILITY LED turns
off.
6.4.3 Online test mode
The online test mode allows the BL-600 Series to display the reading reliability in
real time during normal reading operation.
■ Operation
1. Set the online test mode.
1) Send the “#TEST1” command to the BL-600 Series using the [[Monitor]]
screen of the setup software. ➮ See page 62.
2) The setting is completed when a response to the sent command “OK” is
returned from the BL-600 Series.
2. Read bar codes with the BL-600 Series.
After the trigger input turns off, the BL-600 Series sends the read data and
displays the reading reliability with the STABILITY LEDs.
3. Quit the online test mode.
1) Send the “#QUIT” command to the BL-600 Series using the [[Monitor]]
screen of the setup software. ➮ See page 62.
2) The mode is ended when a response to the sent command “OK” is returned
from the BL-600 Series.
Note: The command setting is only effective if the BL-600 Series is turned on. The
setting will be reset when the power is turned off.
LASER ON
OK/NG TIMING
TEST
Press once.