KEYENCE BL-600 Series - Manual (Page 87)

77
Chapter 5 Installation
5
5.1.4 Mounting the BL-650HA/651HA
The following is the procedure for mounting the BL-650HA/651HA with the supplied
mounting bracket. To mount the BL-600 Series without the mounting bracket, refer
to “Mounting the BL-600 Series without the mounting bracket” on page 79.
1. Check the surroundings of the mounting position.
Check the surroundings according to “5.1.1 Situations to check for before
installing the BL-600 Series” on pages 72 and 73.
2. Attach the BL-600 Series to the mounting bracket.
* The mounting bracket for the BL-650HA/651HA allows two mounting orienta-
tions. Choose the appropriate orientation according to the application.
➮ Refer to page 155 for the dimensions of the mounting bracket.
3. Temporarily fix the mounting bracket.
Since the BL-650HA/651HA emits a laser beam at an angle of 17 °, install the
unit parallel to the surface of the bar code as shown below.
➮ See “5.1.2 Mounting angle and distance” on page 74 for the mounting distance.
* The laser beam application angle for the BL-650HA/651HA is 17 ° ±3° with
reference to a line perpendicular to the rear surface of the unit.
Laser beam
Mounting bracket
Supplied mounting
screw (M3)
Mounting bracket
Supplied mounting
screw (M3)
Laser beam
Mounting bracket
Bar code
Parallel
BL-650HA/651HA
Mounting bracket
Bar code
Parallel
BL-650HA/651HA
Mounting bracket
Bar code
BL-650HA/651HA
Mounting bracket
Bar code
BL-650HA/651HA