KEYENCE BL-600 Series User Manual
Page 75
65
Chapter 4 Setup Software
4
4.5.3 Starting the test mode
The test mode of the BL-600 Series can be started with a command button.
1. Set the communication parameters of the personal computer according to those
of the BL-600 Series.
➮ See pages 54 and 55.
2. Click on [[Monitor]]. The MONITOR screen will appear.
3. Start the test mode by clicking the [TEST1] or [TEST2] button.
Operation of the BL-600 Series
[TEST1] button: Activates the reading rate check mode.
[TEST2] button: Activates the tact check mode.
*
You can also start the test mode by typing “TEST1” or “TEST2” (uppercase
only) in the “Send Command” field and sending it.
4. When the [QUIT] button is clicked, test mode is finished.
*
You can also end the test mode by typing “QUIT” in the “Send Command”
field and sending it.