KEYENCE BL-600 Series - Manual (Page 58)

Chapter 4 Setup Software
48
4
If the PLC link is used
Set the following items.
➮ Refer to “Chapter 8, PLC Link” for details.
“Connected PLC”
Specify the model of the PLC to be connected.
“PLC trigger area” ➮ See page 137.
Check “Enable” to send a trigger signal to the BL-600 Series using the PLC
link.
“Station No.”
Specify a station number between 0 to 31.
“DM head address” ➮ See page 135.
Specify a value for the head address of DM within the range of 0000 to 9900.
“File Register enable”
1. Select “File Register enable” to use the file register ( ➮ See page 131.) as a
device.
2. If the file register is enabled, the following screen appears. Specify a
value, within the range of 000 to 255, for the block number of the file
register to be used.
“Station No.”
* “Station No.” is
not displayed if
“KEYENCE KV
Series” is selected
for “PLC setup”.
“File Register enable”
* “File Register enable” is
only displayed if
“MELSEC-A Series” is
selected for “PLC setup”.
“DM head address”
[Character] button
➮ See step 2 on page 47.
“Connected PLC”
“PLC trigger area”