KEYENCE BL-600 Series - Manual (Page 126)

Chapter 7 Serial Communication
116
7
● Online test ON
Command: #TEST1
Response: OK
● Online test OFF
Command: #QUIT
Response: OK
Command: BCLR
Response: OK
Command: SSET
Response: OK
● Laser off
Command: LOCK
Response: OK
● Resetting Laser off
Command: UNLOCK
Response: OK
• When the Laser off command is executed, bar code read operation (laser
emission) is disabled until the Laser off command is reset by using UNLOCK
command.
• The Laser off command is retained even after the power is turned off.
Command: RESET
Response: OK
Online test mode
Sets to online test mode. ➮ See pages 99 and 100.
Clearing transmission buffer
Clears data stored in the transmission buffer.
Shift to setting mode
Enters the setting mode. ➮ See page 118.
Laser off/Resetting Laser off
Turns off the laser emission when the laser beam may cause injury to an operator.
➮ See page 4.
Reset
Resets the BL-600 software.