KEYENCE BL-600 Series - Manual (Page 55)

45
Chapter 4 Setup Software
4
4.2.3 [[Comm Settings-1]] (Communication parameters 1) screen
Set the following items.
“Baud rate”
“Data bits”
“Stop bits”
“Parity”
Set these communication parameters according to the settings of the exter-
nal devices that will be connected (PC, PLC, etc.).
“Multi-drop link (RS-485)”
➮ See “Multi-drop controller N-400 User’s Manual”.
1. Select “Enable” to use multi-drop link.
* If the multi-drop link is enabled, “RTS/CTS” is disabled.
2. The “ID number (1-31)” setup box appears. Specify the ID number as a
value between 1 to 31. Be sure not to set the same number for different
BL-600 units in the same multi-drop link.
“RTS/CTS” ➮ See page 112.
Select “RTS/CTS” to suspend read data transmission with the CTS signal of
RS-232C.
“Baud rate”
“Stop bits”
“RTS/CTS”
“Parity” “Data bits”
“Multi-drop link
(RS-485)”
“RTS/CTS”
Cannot be selected.
“ID number (1-31)”