KEYENCE BL-600 Series - Manual (Page 92)

Chapter 5 Installation
82
5
■ DIN-rail mounting
1. Check that the DIN-rail mounting claw is in the condition shown in the figure.
2. Attach the BL-U1 to the DIN rail as shown in the figure.
■ Removal from a DIN rail
1. Pull the mounting claw down until it is in position B. Disengage the BL-U1 from
the DIN rail.
2. After removal, push the mounting claw back to position A.
Front view
Fixed claw
Mounting the BL-U1 to a DIN-rail
DIN rail
DIN-rail mounting claw
1. Hook the BL-U1
to the rail.
DIN rail
Fixed claw
2. Push the bottom
of the BL-U1
against the rail.
Mounting claw
A B
Pull the claw down using
a screwdriver, etc.
Mounting claw