EVCO EVFTFT818P7U Installer manual - Manual (Page 43)

EVCO S.p.A. EVFTFT818 | Installer manual ver. 2.1 | Code 144FTFT818E214
page 43 of 94
6.12.1 Selecting the evaporator fan speed
Operate as follows:
1. Make sure the device is in the "on" status.
2. Make sure that the keyboard is not locked and that no procedure is in progress.
3. Press and release the key (1), press and release the key (2) and then press and release the key (3)
or the key (4). The LED bars will supply information relative to fan speed (for example, one bar corresponds
to speed 1, two bars on correspond to speed 2, three bars on correspond to speed 3, etc.).
Alternatively:
4. Make sure the device is in the "run" status.
5. Make sure that the keyboard is not locked and that no procedure is in progress.
6. Press and release the MENU key and then press and release the key or the key to select the evaporator
fan speed
7. Press and release the key or the key to modify these values and then press the ESCAPE key to memorise
it.
Operate as follows to exit the procedure:
8. Press and release the ESCAPE key or do not operate for 60 s.
The fan is switched on at the selected speed after 5 s from release of the key or the key.
6.13 Pre-cooling start-up
Every operating cycle can be preceded by pre-cooling.
Operate as indicated to start pre-cooling:
1. Make sure the device is in the "on" status.
2. Make sure that the keyboard is not locked and that no procedure is in progress.
3. Press and release the key (1) and then press and release the START/STOP key (2).