EVCO EVFTFT818P7U Installer manual - Manual (Page 48)

EVCO S.p.A. EVFTFT818 | Installer manual ver. 2.1 | Code 144FTFT818E214
page 48 of 94
3. Press and release the key (1) or the key (2) to select the program number and then press and release
the key (3) in order to associate a name.
4. Press and release the key, the key, the key or the key to select the character and then press and
release the key to confirm it.
5. Press and release the key, the key, the key or the key to select “[END]” and then press and
release the key.
Operate as follows to abandon the procedure indicated:
6. Press and release the ESCAPE key or do not operate for 60 s.
7.3 Execution of a program
Operate as follows:
1. Make sure the device is in the "on" status.
2. Make sure that the keyboard is not locked and that no procedure is in progress.
3. Press and release the key, press and release the key or the key to select the program and then
press and release the START/STOP key to start it: the operating cycle will be started with the settings
memorised in the program.