EVCO EVFTFT818P7U Installer manual - Manual (Page 72)

EVCO S.p.A. EVFTFT818 | Installer manual ver. 2.1 | Code 144FTFT818E214
page 72 of 94
6. Insert an USB peripheral in the USB serial port; make sure the peripheral contains the text document by name
“param.txt” (see point 3).
7. Press and release the key (1) to select “UPLOAD PARAMETERS”, then press and release the key (2): it
will automatically be started the reading (from the peripheral) of the text document by name “param.txt”
(containing information about the configuration parameters); the reading procedure can take some minutes.
8. To the end of the upload remove the USB peripheral from the USB port.
12.3 Upload and download of the programs
To make the download of the programs operate as follows:
1. Make sure the device is in the “stand-by” status.
2. Insert an USB peripheral in the USB serial port.
3. Press and release the key (1) to select “DOWNLOAD PROGRAMS”, then press and release the key (2):
it will automatically be started the writing (into the peripheral) of a text document by name “ricette.txt”
(containing information about the programs); the writing procedure can take some minutes.