Fire and burglar alarm – FingerTec Ingress User Manual
Page 31
31
8. Select the nature of Antipassback by clicking at the radio button.
Antipassback between readers of Door 1:
To activate feature at Door 1 only.
Antipassback between readers of Door 2:
To activate feature at Door 2 only.
Antipassback between readers of Door 1 and between the readers of Door 2 respectively:
To activate the
features at both Door 1 and Door 2 independently.
Antipassback between Door 1 and Door 2:
To activate the feature between both Door 1 and Door 2. User
must have an Out record from Door 1, before granted access to Door 2.
9. Sync settings to the Ingressus controller.
Fire and Burglar Alarm
Apply fire alarm settings to Ingressus to alert users in case of fire emergency. You must install
AUX input component at Ingressus (e.g.: smoke/heat detector). The sensor sends signal to
Ingressus once it detects smoke/heat. You can configure in Ingress to force Ingressus to
unlock doors immediately.
1. Click
Fire Alarm
from the left panel.
2. Click
Add Zone
.
3.
Name
the Zone, e.g.: All doors.
4. Click
Add Device
.
5.
Select
Ingressus from the list.
6.
Name
the Ingressus controller.
7. Press
Edit
at the Details panel.
8. Check the
Fire Alarm
box to start configurations.
Trigger condition:
To define the action that will trigger the fire alarm in Ingressus. You can either use
sensors (connecting to AUX port at Ingressus) or key command from slave terminals (insert special
password, verification of duress finger). For example, select Auxiliary Input Shorted if you are using
smoke/heat sensor to detect fire. The sensor connects to Ingressus at its AUX Input port. It only send
signal to Ingressus in case it detects smoke or heat.