FingerTec Ingress - Manual (Page 60)

60
You can also determine whether an employee needs to press a key button to define his/her
status during clocking. Click the checker if you want to.
Rounding Rules
Rounding is to determine the “rounding of minutes” rules allowed in the clocking schedule
and the rules will determine the presentation of time in the attendance sheet.
Learn about it in the table below:
Round the work time to the nearest (minutes)
Round Up Work hour is rounded up to the nearest minute and is set to 15, hence all minutes
will be rounded up as per below:
1-15 minutes = 15
16-30 minutes = 30
31-45 minutes = 45
46-59 minutes = 1 hour
Round Down Work hour is rounded down to the nearest minute and is set to 15, all minutes will be
rounded down as per below:
1-15 minutes = 0
16-30 minutes = 15
31-45 minutes = 30
46-59 minutes = 45
Round Midpoint Once you insert a value here, the software will calculate the value’s midpoint. For
example if you set the value at 15 min, the midpoint would be at 7 min. The clocking
schedule’s IN time is 9.00am and the midpoint is 7 min.
If the user verifies in less than 7 minutes after the IN time, for example 9.07 a.m., the
software will round down the transaction data to be displayed as 9.00am. If the user
verifi es more than 7 minutes after the IN time, the software will round up the trans-
action data to be displayed as 9.15 a.m.