Comtech EF Data CRS-170A - Manual (Page 48)

CRS-170A L-Band 1:1 Redundancy Switch MN/CRS170A.IOM
Switch Connectors and Pinouts Revision 13
3–6
3.2.2 Antenna Side Connectors
• See Sect. 1.3.1 in Chapter 1. INTRODUCTION for information about the LED
Indicators.
• See Sect. 1.3.1 in Chapter 1. INTRODUCTION and Sect. 4.9 in Chapter 4. MODEM
AND SWITCH CONFIGURATION for information about the “Switch Conditions”
and “Intelligent / Dumb Controller” DIP Switches.
Figure 3-4. CRS-170A – Antenna Side Connectors and Ground Stud (Rev. A and
Later Version)
3.2.2.1 RF Connectors (50Ω Type ‘N’)
Two 50Ω Type ‘N’ female connectors on the antenna side of the
CRS-170A provide the coaxial cable connections to the outdoor receive
and transmit equipment.
Table 3-4. J7 | Rx and J8 | Tx ‘Type ‘N’ Connectors
Ref Des Name Connector Type Function
J7 Rx Type ‘N’ RF Input
J8 Tx Type ‘N’ RF Output
3.2.2.2 Ground Stud
CAUTION – PROPER GROUNDING PROTECTION IS REQUIRED. THE INSTALLATION
INSTRUCTIONS REQUIRE THAT YOU MUST ENSURE THE INTEGRITY OF THE
PROTECTIVE EARTH AND THAT YOU MUST MAINTAIN THE EQUIPMENT’S
CONNECTION TO THE PROTECTIVE EARTH AT ALL TIMES.
Use the #10-32 stud provided on the antenna side of the Switch for connecting a
common chassis ground among equipment.