Powering up the mps450 – Fluke Biomedical MPS450 User Manual
Page 21
Advertising
Introduction
and
Specifications
Powering Up the MPS450
1
1-7
Powering Up the MPS450
1. Power up the system by pressing the power-on/off key (the green key located on the
keypad of the unit, bottom/right). After one short beep, the LCD screen displays the
following startup message:
gje001.eps
2. After a three-second display test, the following top menu displays:
gje002.eps
Note
Once you have the MPS450 up and running, please fill out the Registration
Card and mail it to Fluke Biomedical.
Advertising