Fluke Biomedical MPS450 - Manual (Page 4)

Repair and calibration:
To find the nearest service center, go to
www.flukebiomedical.com/service , or
In the U.S.A.:
Cleveland Calibration Lab
Tel: 1-800-850-4606
Email: [email protected]
Everett Calibration Lab
Tel: 1-888-993-5853
Email: [email protected]
In Europe, Middle East, and Africa:
Eindhoven Calibration Lab
Tel: +31-402-675300
Email: [email protected]
In Asia:
Everett Calibration Lab
Tel: +425-446-6945
Email: mailto:[email protected]
Certification
This instrument was thoroughly tested and inspected. It was found to meet Fluke Biomedical’s manufacturing specifications
when it was shipped from the factory. Calibration measurements are traceable to the National Institute of Standards and
Technology (NIST). Devices for which there are no NIST calibration standards are measured against in-house performance
standards using accepted test procedures.
WARNING
Unauthorized user modifications or application beyond the published specifications may result in electrical shock hazards or
improper operation. Fluke Biomedical will not be responsible for any injuries sustained due to unauthorized equipment
modifications.
Restrictions and Liabilities
Information in this document is subject to change and does not represent a commitment by Fluke Biomedical. Changes made
to the information in this document will be incorporated in new editions of the publication. No responsibility is assumed by
Fluke Biomedical for the use or reliability of software or equipment that is not supplied by Fluke Biomedical, or by its
affiliated dealers.
Manufacturing Location
The MPS450 Multiparameter Simulator is manufactured at Fluke Biomedical, 6920 Seaway Blvd., Everett, WA, U.S.A.
Applicable Testing Standards
Fluke Biomedical’s MPS450 ™ Multiparameter Simulator (hereafter referred to as the
MPS450) has been tested by an independent laboratory and meets the requirements listed
here.
Safety Requirements
USA UL 61010-1 (2 nd Edition). General requirements.
Canada CAN/CSA C22.2 No. 61010 (2 nd Edition), Safety
requirements for electrical equipment for measurement,
control and laboratory use.
EC Directive 2006/95/EC IEC/EN 61010-1:2001 (2 nd Edition), safety requirement for
electrical equipment for measurement, control, and
laboratory use.
Electromagnetic Interference and Susceptibility
EN 61326-1:2006 Emissions Class A and Immunity
FCC Class A
Warning: Changes of modifications to this unit not expressly approved by the