Hypertherm HT4001 Plasma Arc Cutting System - Manual (Page 206)

WIRING DIAGRAMS
4-95
8-2
HT4001
Instruction Manual
Information
This section contains the wiring diagrams for the HT4001 system. When tracing a signal path or referencing with
the Parts List or Troubleshooting sections, please be aware of the following format to assist you in understanding
the wiring diagrams' organization:
• Sheet numbers are located in the lower right-hand corner.
• Page-to-page referencing is done in the following manner:
Destination and Source Coordinates refer to letters A-D on the Y-axis of each sheet and numbers 1-4 on the
X-axis of each sheet. Lining up the coordinates will bring you to the source or destination blocks (similar to a
road map).
Wiring Diagram Symbols
Wiring diagram symbols and their identification precede the system wiring diagrams in this section.
C
C
SHEET
4-D3
SHEET
2-B2
Source Connection Source Reference Block Destination Sheet # Destination
Coordinates
Source Sheet # Source Coordiates Source Reference Block Destination
Connection