Hypertherm HT4001 Plasma Arc Cutting System - Manual (Page 55)

INSTALLATION
8-97
4-2
HT4001
Instruction Manual
Upon Receipt
The HT4001 system is shipped mounted on skid(s) and protected by heavy carton covers. Before unpacking,
inspect the cartons for evidence of damage during shipment. If there is evidence of damage, refer to Claims for
damage during shipment below for details.
1. Remove all packing material and discard. Remove the units and items from the shipping skid.
2. Verify that the components of the HT4001 system, optional units, cables and hoses, and items listed below are
included.
Alert your distributor or Hypertherm if any of the items are damaged or missing. All communications regarding this
equipment must include the model number and serial number (located on the back of the HT4001 power supply).
Refer to Claims for defective or missing merchandise below for details.
Claims
Claims for damage during shipment — If your unit was damaged during shipment, you must file a claim with the
carrier. Hypertherm will furnish you with a copy of the bill of lading upon request. If you need additional assistance,
call our Customer Service group at 1-800-737-2978.
Claims for defective or missing merchandise — All units shipped from Hypertherm undergo rigorous quality
control inspections for defects. If any of the merchandise is defective or missing, call your distributor for help. If you
need additional assistance, call our Customer Service group at 1-800-737-2978.
HT4001 System Components
• HT4001 Power Supply
• Remote High Frequency Console
• Remote Voltage/Current Control
• Gas Console
• Motor Valve Console
• Cable
• Hoses
• Torch lead set to Motor Valve Console
• Shielded torch lead set to RHF Console
• Machine Torch
• Consumable spare parts kit
Optional Units
• Initial Height Sensing
• Water Muffler System
• Timer/Counter
• H-401 Slave
• Water Chiller