Hypertherm HT4001 Plasma Arc Cutting System - Manual (Page 5)

4
Changed Page Description IM200 Rev 4 to 5 4/14/97
5.25&26 Changed 120468, 120469 to 120470, 120471
2.05,3.02,5.09&
13
Added tolerance to gas pressures
6.10 &.11 Removed resistor, cap from I/O panel
6.21 Added 011081 float stop
6.42-45 removed qtys from consumable parts list
6.46 removed non-ce retaining caps from CE consumable parts kits
6.47 Added 011081 float stop
8.05 Uprevved wiring diagrams to EE (14 pgs)
0.05 Updated TOC for torch coolant draining
7.01 Added torch coolant draining
7.03 Referenced torch coolant draining
7.30 Added torch coolant draining procedure
4.10 Added omitted signals to gas console cable
0.01 Uprevved to 5 - implement 4/14 with serial#514
2.09 Corrected dimension on gas console holes
5.20 Corrected reference to PAC611 - to PAC620
4.06 Referenced to section 6 for complete list of cable and hose lengths
6.31-.40 additional lengths
Changed Page Description IM200 Rev 5 to 6 8/15/97
7.03 added note to check contactor contacts
7.04 & 05 bumped page
0.01 Uprevved to 6 - implement 8/15 with serial#539
0.02 Changed customer service tel. #
3.11 Changed light...contactor to lights...contactors
4.02 Changed customer service tel. #
6.14 Changed dwg of power supply rear wall inside
6.15 Added in-rush components to parts list
7.09 & 10 Added CON2 to sequence of operation
7.12 Changed light...contactor to lights...contactors
8.05 Uprevved wiring diagrams to GG (14 pgs)
2.05 changed OCV spec to 361V
7.22 & 23 Corrected chopper test procedure