Hypertherm HT4001 Plasma Arc Cutting System - Manual (Page 79)

INSTALLATION
11-97
4-26
HT4001
Instruction Manual
Gas Console Connections
See page 4-10 for power supply connections to gas console, page 4-22 for RHF console connections to gas
console and page 4-4 for torque specifications.
Oxygen Supply Hose – Gas Console to Oxygen Supply
Nitrogen Supply Hose – Gas Console to Nitrogen Supply
Injection Water Hose – Gas Console to Torch
1. Slide the injection water hose through the torch insulating sleeve.
2. Using a 7/16" open-end wrench on the left-handed torch fitting and a 7/16" open-end wrench on the left-
handed injection water hose fitting, turn the water-hose fitting in a counterclockwise direction to tighten.
3. Make injection water hose connection at gas console (Fig. 4-14).
See page 4-30 to connect plasma gas lead to torch.
18
19
20
RED RED
Left-hand fitting
Note: If cutting with nitrogen as the
plasma gas, the oxygen hose
does not need to be connected to
the gas console.
Note: If cutting with oxygen as the
plasma gas, nitrogen must also
be connected to the gas console
to achieve the proper oxygen-
nitrogen mixtures in the preflow
and cut flow conditions.
Part No. Length
024335 26 in (.6 m)
024315 5 ft (1.5 m)
024046 6 ft (1.8 m)
024032 10 ft (3 m)
024261 11.5 ft (3.5 m)
024130 12 ft (3.6 m)
024132 14 ft (4.2 m)
Part No. Length
024033 15 ft (4.5 m)
024018 20 ft (6 m)
024034 25 ft (7.5 m)
024035 30 ft (9 m)
024036 35 ft (10.5 m)
024037 40 ft (12.2 m)
Part No. Length
024208 45 ft (13.7 m)
024258 50 ft (15 m)
024179 53 ft (16 m)
024128 60 ft (18 m)
024345 75 ft (23 m)
024346 100 ft (30.5 m)
Part No. Length
024204 15 ft (4.5 m)
024205 25 ft (7.5 m)
024155 50 ft (15 m)
Part No. Length
024206 100 ft (30.5 m)
024159 150 ft (46 m)
024333 200 ft (61 m)
Part No. Length
024210 10 ft (3 m)
024203 15 ft (4.5 m)
024232 20 ft (6 m)
024134 25 ft (7.5 m)
024211 35 ft (10.5 m)
024112 50 ft (15 m)
Part No. Length
024148 75 ft (23 m)
024116 100 ft (30.5 m)
024120 150 ft (46 m)
024185 180 ft (55 m)
024124 200 ft (61 m)