Hypertherm HT4001 Plasma Arc Cutting System - Manual (Page 232)

APPENDIX A
a-10
HT4001
Instruction Manual
H401 Slave Connections (cont.)
When using the H401 Slave, a positive and negative lead must connect the HT4001 to the H401. Two 25-foot
cables (023136) come with the 077011 kit for this purpose.
Also, an additional positive lead must run from the positive bus bar in the HT4001 power supply to the work table,
and an additional negative lead must run from the negative bus bar in the HT4001 power supply to the cathode
block of the RHF console.
Refer to Fig. a-6.
Positive Lead – HT4001 Power Supply to H401 Power Supply
Negative Lead – HT4001 Power Supply to H401 Power Supply
Positive Lead – HT4001 Power Supply to Work Table
Negative Lead – HT4001 Power Supply to RHF Console
31
32
33
34
Part No. Length
023136 20 ft (6 m)
023078 25 ft (7.5 m)
023101 30 ft (9 m)
023135 40 ft (12 m)
023079 50 ft (15 m)
Part No. Length
023124 75 ft (23 m)
023080 100 ft (30.5 m)
023081 150 ft (46 m)
023316 180 ft (55 m)
023188 200 ft (61 m)