Hypertherm HT4001 Plasma Arc Cutting System - Manual (Page 67)

INSTALLATION
10-99
4-14
HT4001
Instruction Manual
Power Supply Connections (cont.)
Machine Interface V/C Cable – PS to Machine Interface
Note: If HT4001 system uses the digital remote V/C unit to set voltage and current, skip this step. The
machine interface V/C cable is used only with the programmable remote.
Before connecting the machine V/C interface cable, see the wiring diagrams in this manual and verify that the
correct plug is attached to the µP control PCB REC6 receptacle.
PS END
SCKT
COLOR DESCRIPTION
1 Black Current 5
2 Wht Current 10
3 Red Current 20
4 Green Current 40
5 Orange Current 80
6 Blue Current 100
7 White/Black Current 200
8 Red/Black Current 400
9 Green/Black Current 800
10 Shield Shield
11 Blue/Black Current ICom
12 Black/White spare
13 Red/White spare
14 Green/White Voltage V1.25
15 Blue/White Voltage V2.5
16 Black/Red Voltage V5
17 White/Red Voltage V10
18 Orange/Red Voltage V20
19 Blue/Red Voltage V40
20 Red/Green Voltage V80
21 Orange/Green Voltage V100
22 Black/White/Red Voltage V200
23 White/Black/Red Voltage VCom
8
PS End
1X7
Part No. Length
023851 15 ft (4.5 m)
023852 25 ft (7.5 m)
023853 35 ft (10.6 m)
023854 50 ft (15 m)
Part No. Length
023855 75 ft (23 m)
023856 100 ft (30.5 m)
023903 125 ft (38 m)
023857 150 ft (46 m)
023858 200 ft (61 m)