NavCom StarUtil-2110 Rev.B - Manual (Page 22)

StarUtil-2110 User Guide – Rev. B
Figure 11: Rover / Navigation & Tracking Setup Window
9 Unit Port Configuration Button: Click this button to configure the baud rate of the receiver
ports. The Unit Port Configuration window opens (see Figure 11). Refer to the section
above, Configure Baud Rate of Receiver Ports, for more information.
9 Antenna Setup Button: Click this button to set the appropriate bias adjustment values for the
antenna model in use (optional). The Vertical Antenna Bias window opens (see Figure 12):
• Phase Center Adjustment (H1): The offset in millimeters from the physical center of the
antenna (the element) to the Mechanical Reference Plane (MRP). The MRP is at the
bottom of the BSW antenna mount. The range limits are -128 to 127.
• Radius of Antenna Body (R): The measurement in millimeters from the physical center of
the antenna to the edge of the antenna. For a pole, enter 0. For a tripod, the range limits
are -32768 to 32767.
• Slant Range of Antenna Body: For a pole, the vertical measurement in millimeters from
the Mechanical Reference Plane (MRP) to the control point. For a tripod, the
measurement in millimeters from the edge of the antenna to the control point. The range
limits are -32768 to 32767.
3-20