Figure 34: message type menu, Figure 35: port menu, Figure 34) – NavCom StarUtil-2110 Rev.B User Manual
Page 42
StarUtil-2110 User Guide – Rev. B
Figure 34: Message Type Menu
Configure
Messages
9
Port: Right-click on the Port cell to select Port A, Port B, or Bluetooth, depending on the
current port connection (see Figure 35).
Figure 35: Port Menu
9
Rate: Use of the default rate value (On Change) is recommended for all NMEA messages.
The term On Change indicates that the receiver will output the specified message each time
new data is available.
The NMEA messages GGA, RMC, and VTG match the output of the navigation
rate when scheduled as “On Change”. These messages may be output at rates
higher than 1Hz. The 5Hz and 10Hz navigation rates are purchased software
options. Refer to the description of the
on the Rover /
Navigation & Tracking Setup window for more information.
If desired, right-click on the Rate cell to open the menu to schedule the frequency of output
for a message (see Figure 36).
• Specific Period: Enter a value in seconds in the Rate cell.
• Other:
o
All SVs: Not Applicable
4-40