NavCom StarUtil-2110 Rev.B - Manual (Page 30)

StarUtil-2110 User Guide – Rev. B
Figure 23: Rate Menu
• Specific Rate: Select 1Hz, 5Hz, or 10Hz. NCT binary messages do not output at 5Hz or
10Hz unless the user purchases a license for those navigation rates.
• Specific Period: Enter a value in seconds in the Rate cell.
• Other:
o All SVs: Not Applicable
o *On Trigger: Select this option to schedule the SF-2110 to accept an event input
pulse to synchronize external incidents requiring precise GPS time tagging, such as
aerial photography. For example, the action of a camera’s aperture creates an input
pulse to the Event port. The SF-2110 outputs position and time information relative to
each photograph taken. Refer to
Chapter 8, 1PPS/Events for more information.
o Special Value: Not Applicable
„ Delete Messages
To delete one or more messages:
9 Right-click on a message. A menu opens. Select Delete at the bottom of the menu to delete
the message.
Or
9 Click on a message to highlight it. Press the Delete key on the keyboard.
9 Press the Clear button to clear all messages from the list so that new messages may be
easily added.
‡
This action is not complete until the Apply button or OK button is clicked. Failure
to send the deleted list causes the previous list to be retained.
View NCT Binary Message Output Data
The View menu provides access to the output data of common NCT Binary Messages (see
Figure 24).
‡
Refer to the sections below for details on the output data for messages
86-Channel Status, A0-Alerts, B0-Raw Measurements, B1-Solution Plot,
B1-Solution, and EC-5C Delta Time. Refer to Figure 57 for details on message
30-Software Options. Refer to the section, View Menu – StarFire Information, for
details on messages pertaining to the StarFire subscription service.
* Consult Release Notes on the NavCom web site for availability.
4-28