Chapter 5 log output data, Log data – nct binary messages, Chapter 5 – NavCom StarUtil-2110 Rev.B User Manual
Page 45: Log output data, Figure 38: nct binary messages data logging window, Figure 38), Figure 38, Refer to, For instruct
StarUtil-2110 User Guide – Rev. B
Chapter 5 ............................................................................Log Output Data
This chapter provides instructions to log output data for NCT Binary Messages and NMEA
Messages. Log data from either of the physical ports. This data can be used in a number of
industry standard GPS data analysis programs either in NCT Binary format, after conversion to
RINEX format, or by using the NMEA output.
Log Data – NCT Binary Messages
The data from NCT Binary Messages scheduled for output may be:
9
Logged continuously in a single file
9
Logged in 24-hour data file splits
Almanac & Ephemeris data currently in the receiver’s NVRam is automatically
downloaded to the data file when logging is initiated, regardless of whether the
Almanac & Ephemeris messages are scheduled for output in the NCT Binary
Messages window.
9
Click the
icon on the toolbar to log data to a file. The data logging window opens (see
Figure 38). The Current Status area of the window indicates: if logging is enabled, if the
scheduler [24-hour splits] is enabled, and the path to the log file.
To open the data logging window from the menu bar, select File > Log Data to File.
Figure 38: NCT Binary Messages Data Logging Window
5-43