Teac GigaPulse - Manual (Page 180)

180
GigaPulse
™
User Guide
Im
pu
lse
Bu
ild
er-
Ad
va
nc
ed
O
ptio
ns
Impulse Builder-Advanced Options
180
Use XY Coordinates:
This mode is preferential if you’re working from an image editor.
Note that the origin is the upper/left corner in this mode.
Note that down is a POSITIVE Y direction, and up is NEGATIVE Y direction.
Use Radial Coordinates:
This mode is preferential if you’re in an actual room and measuring the distances to
placements (Radius) from a central location.
Note that the origin is the central location in this mode.
Angle are measured in degrees (not radians) and
0 or 360 degrees is right of the origin
90 or -270 degrees is in front of the origin
180 or -180 degrees is left of the origin
270 or -90 degrees is behind the origin
Auto Calculate:
Pressing this button scans the placement position of your
source and microphone placements and provides you with
the rectangle that bounds these points.
This rectangle is always displayed in XY coordinates.