Teac GigaPulse - Manual (Page 186)

186
GigaPulse
™
User Guide
Im
pu
lse
Bu
ild
er-
Att
rib
ut
es
Impulse Builder-Attributes
186
Overlap-Level-Cutoff:
Overlap Control – Has a minimum/maximum span of 0-127. This is a timing offset and
cross-fade parameter for the Tail Model signal, convolved with the source material of
the original impulse response.
Level Control – The level control allows the Tail Model signal level to be adjusted to the
original signal.
Cutoff Control – The cutoff control is essentially a low pass filter. It permits the tonal
quality of the Tail Model signal to be matched to that of the original signal.
Apply These Values To All Source Placements:
Pressing this button will force the tail extension settings for the current source
placement set to all the other placements sets.
If any of the other impulse sets have an impulse length that is too small for tail
extension, you will be given the option to skip the setting or increase the impulse set’s
impulses to the minimum size that supports tail extension.