Verilink T1 Access Router (34-00327) Product Manual - Manual (Page 139)

V T 1 0 0 I n t e r f a c e 4-31
Router unit here. This DLCI can be used for management only, or for
management and actual data.
If this parameter is set, a PC connected to the LAN interface of this T1
Access Router can reach a remote T1 Access Router through this DLCI. The
remote IP address must be part of an IP network that is different from the
local T1 Access Router, and the local T1 Access Router's IP address must be
configured into the PC. This way, local and remote T1 Access Routers can be
reached regardless of the availability of the routers connected at the back of
the T1 Access Routers.
Values: IP address
Default: 0.0.0.0
Remote IP Mask If the Remote IP Address is set, the Remote IP Mask must also be set.
Values: IP address
Default: 0.0.0.0
Type If data received from this DLCI has to be switched to its corresponding
destination port, you must set the type to “Switched.” Set the type to “Local”
if this DLCI will be used for management purposes only.
Values: Switched, Local
Default: Switched
Delete Endpoint You may delete any endpoint.
Endpoint Service Details Screen
Selecting from the <Svc> column on the Endpoint Table screen displays the
typical Service Details screen (page 4-15) in which you can view, and in some
cases change, parameters including Index, Interface, Type, and Pair. A “Delete
Service” prompt is also included on this screen.
DLCI Details Screen
The DLCI Details screen (Figure 4.27) lets you access the configuration
parameters described in the following paragraphs. To bring up this screen,
select any DLCI from the <DLCI> column on the Endpoint Table screen.