Verilink T1 Access Router (34-00327) Product Manual - Manual (Page 19)

A b o u t t h e T 1 A c c e s s R o u t e r 1-5
Features Summary
• A Powerful Core Architecture:
• 10/100Base-T Ethernet port for Management or IP Gateway
• Supervisory port for local management via VT100
•
Router/Bridge:
• Frame Relay or PPP
• 10/100Base-T Ethernet port
• Static routes
• Static Address Resolution Protocol (ARP)
• Dynamic routing protocols, including RIP 1, RIP 2, and OSPF
• Un-numbered Network
• Address Management: NAT and DHCP
• Programmable alarm thresholds
•
Configurable Serial (Data) Port:
• Supports V.35, EIA-530, and RS-232
• Security Features
• IP Host Access List
• Multilevel password access
• NAT
•
A Suite of Performance Monitoring Tools:
• Monitoring capability for up to 128 virtual circuits (Data Link Connection
Identifiers, or DLCIs)
• T1/FT1 performance monitoring, including complete diagnostic
capabilities and test modes
• SLA monitoring and management
• Committed Information Rate (CIR) enforcement per DLCI
• Programmable alarm thresholds
• E-mail notification of alarm status for immediate notification of
potential network problems
•
Management Interfaces:
• WANsight
−
an innovative, embedded Web-based user interface for
remote configuration and real-time reporting via Web browser (Verilink
recommends Microsoft Internet Explorer 5.0 or higher) that decreases
installation and configuration time for service employees, simplifies
troubleshooting and fault isolation of network problems, and optimizes
management of both TDM and frame-based services
• VT100 or TELNET