Verilink T1 Access Router (34-00327) Product Manual - Manual (Page 95)

W e b S e r v e r I n t e r f a c e 3-67
Figure 3.62 NAT Ports Screen
Endpoint The Endpoint name of the circuit associated with the LAN or WAN port.
Default is LAN for the first port.
Enable Enables or disables the NAT port. Default is “Enable.”
Default Translation Forces translation on a specific IP port regardless of the source IP Address. If
Default Translation is set to “Enable,” the packet will never be discarded, but
will always pass through the translation path. Therefore, any packets with a
destination address different from the global/Internet network address will be
processed by the IP Gateway, and may be routed to another port. If this
parameter is set to “Disable,” no packet with a destination address different
from the global/Internet address will be processed. Setting this parameter to
“Disable” will override an “Enable” parameter set under “Filter Non Local
Address” on the NAT Details menu.
Type Defines whether this port is local or global. Default is LAN global. All others
are local.
IP Address IP Address of this port. Default is the value defined in the IP Gateway Circuit
Table.
Mask Mask related to the defined IP Address. Default is the value defined in the IP
Gateway Circuit Table.
The NAT Port Table screen provides an “Add New” button that lets you add
additional addresses.
Figure 3.63 NAT Port Details Screen