Wavetronix SmartSensor 105 (SS-105) - User Guide - Manual (Page 16)

CHAPTER 1 • INSTALLING THE SMARTSENSOR 105 15
Figure 1.3 – Attaching the Sensor to the Mounting Bracket
Aligning the Sensor to the Roadway
Follow the steps below to correctly align the SmartSensor (see Figure 1.4):
Figure 1.4 – Aiming the SmartSensor
1 Aim the front of the sensor at the center of the detection area. You may also refer to
Figure 1.1 as an illustration of where to aim the sensor.
2 Adjust the side-to-side angle to within approximately ±2° of perpendicular to the flow
of traffic.
3 Tighten mounting bracket bolts.