Wavetronix SmartSensor 105 (SS-105) - User Guide - Manual (Page 36)

In this chapter
˽ Serial Connection
˽ Modem Connection
˽ Internet Connection
˽ Firmware Upload
˽ Connection Properties
˽ Address Book
˽ Communication Error
4
When the SmartSensor Manager application is opened, you will be taken to the New
Connection page, where you will be able to connect using one of three connection options:
serial, modem, or Internet. Choose the desired method of connection and click OK. The
Serial (COM Port) radio button will be selected by default (see Figure 4.1).
You can also access the three connection options at any time by going to File > New Con-
nection.
Note
Selecting a connection type under File > New Connection while you are already on-
nected will terminate your current connection. You can also end a connection by going
to
File > Close Connection.
Communication
4