Wavetronix SmartSensor 105 (SS-105) - User Guide - Manual (Page 63)

62 CHAPTER 6 • LANE SETUP
However, the detection thresholds configured for the sensor during the automatic configu-
ration process are based upon the current level of the gain and will continue to adapt for up
to one minute after clicking the Finished button.
Note
The default starting point of 5 is also the largest starting point allowed. If you enter
a value larger than 5 the default starting point of 5 will be used. If you are managing
the gain, you should generally change the starting point to a 3 or 4.
Lane Configuration – Manual
If the sensor is unable to automatically configure itself to your satisfaction, you can manu-
ally configure it by adding, removing or adjusting lanes, lane dividers and lane centers.
To make changes in Manual mode:
1 With the Lane Configuration page open, select the Manual button; the buttons in
the toolbar on the right of the screen will change from gray to black (see Figure 6.2).
Figure 6.2 – Manual Lane Configuration
2 Selecting a button in the toolbar will allow you to make changes using the roadview
window on the left.
3 Once you’ve made the necessary adjustments, hit Finished to save your changes.
Adjust Lanes
The Adjust Lanes button allows you to click your cursor on any visible shoulder (gray line),