Wavetronix SmartSensor 105 (SS-105) - User Guide - Manual (Page 69)

68 CHAPTER 6 • LANE SETUP
Note
If the connection’s additional response wait time is greater than 500 ms, event and
actuation information is not displayed on the screen.
Traffic (Event) Data
In Event mode, this screen allows you to verify the SmartSensor’s configuration by compar-
ing the traffic on the road to event information shown in the window (see Figure 6.8). In
order to keep a record of your verification results, the event data can also be saved to a log
file while you remain on this screen.
Figure 6.8 – View Traffic (Event) Data
The window can also be used to verify true presence information by switching to Actuation
mode (click the A icon).
Note
A status bar below the Traffic View window indicates whether you are in Event mode
or Actuation mode.
By default, Traffic View launches in Event mode. In Event mode, the vehicles (represented
by the blue rectangles) appear after having passed through the radar detection zone.
The four icons located at the bottom of the screen are active in this mode. They are, from
left to right: