Wavetronix SmartSensor 105 (SS-105) - User Guide - Manual (Page 84)

In this chapter
˽ Hyperterminal
˽ Firmware Upload
8
The Tools menu allows you to view and send messages to and from the sensor, as well as to
upload firmware.
Hyperterminal
Hyperterminal allows you to send message requests and view message responses for any
commands in either Simple or Multi-drop protocols (see Figure 8.1). Enter the request
in the text field marked Command Line located near the top of the screen. Click on the
appropriate radio button to either transmit information all at once after you’ve hit Enter
on the keyboard or to automatically transmit each character as it is typed. The message
response will be returned in the gray scrollable area below the Command Line.
You may also use binary mode to verify operation of binary protocols supported by Smart-
Sensor by clicking the Binary Mode button.
Tools
8