SMA Sunny Boy Control Light - Manual (Page 18)

Sunny Boy Control Light Chapter 2: Commissioning the Sunny Boy Control Light
SUNBCL-11:NE
- 18 -
SMA Regelsysteme GmbH
Automatic Device Detection
Sunny Boy Control Light begins with the detection of all accessible devices.
[ DETECTION ]
searching for
new devices

Fig. 2.7: Sunny Boy Control Light searching for new devices
This process may take several minutes depending on the number of devices that
have to be detected. An hourglass in the lower right corner of the display shows that
the program is active. In the bottom line of the display you will find the serial number
of every detected device.
After each detection cycle all devices found by Sunny Boy Control Light will be
displayed one after the other as follows:
New Device
Type xx
S.No xxxxxxxxxx
accept?
Fig. 2.8: Sunny Boy Control Light detecting new device
Please compare the serial numbers of the devices found by Sunny Boy Control
Light with the serial numbers of your devices, which you have written down before.
Register the devices with
[[[[
Enter
]]]]
in the device list resp. remove devices that you do
not want to register with
[[[[
ESC
]]]]
. Please note that the respective detected device is
registered automatically without confirmation if no key is pressed.
After this you will see the total number of newly registered devices. Please check if all
installed devices were found by Sunny Boy Control Light. If not, you should
activate "
search again search again search again search again
" with
[[[[
Enter
]]]]
.