SMA Sunny Boy Control Light - Manual (Page 55)

Sunny Boy Control Light Chapter 5: Menu Functions for Configuration
SUNBCL-11:NE
- 55 -
SMA Regelsysteme GmbH
Please compare the serial numbers of the devices found by Sunny Boy Control
Light with the serial numbers of your devices, which you have written down before.
Register the devices with
[[[[
Enter
]]]]
in the device list resp. remove devices that you do
not want to register with
[[[[
ESC
]]]]
. Please note that the respective detected device is
registered automatically without confirmation if no key is pressed.
After this you will see the total number of newly registered devices. Please check if all
installed devices were found by Sunny Boy Control Light. If not, you should
activate "
search again search again search again search again
" with
[[[[
Enter
]]]]
.
[ DETECTION ]
new xx devices
tot yy devices
search again?
Fig. 5.29: End of detection procedure
By pressing the
[[[[
Enter
]]]]
key you may re-run the search as it is possible that the
Sunny Boy Control Light does not find all devices in the first search cycle. If no key
is pressed the Sunny Boy Control Light will automatically begin a new detection
cycle after 60 sec. If several attempts were unsuccessful, please check whether you
have correctly installed the devices to be detected. If Sunny Boy Control Light does
not detect a device in spite of a repeated search, please read chapter 7.2,
“Troubleshooting Powerline Communication”.
Finish the device detection by pressing the
[[[[
ESC
]]]]
key.
After this you will be prompted to confirm the configuration. During the initial
installation the number of new devices corresponds with the total number of
registered devices.
[ DETECTION ]
Do you want
to save the
changes?
Fig. 5.30: Saving the detected Sunny Boys