Yaskawa YASNAC PC NC I/O Signal Function Manual - Manual (Page 45)

6 - 4
YASNAC PCNC I/O Signal Function Manual Chapter 6: Operation Support Functions
Fig. 6 Time Chart of Operation Mode Input and Output Signals
(3) Supplements to Operation Mode Input/Output Signals
The items that must be taken into consideration concerning the operation mode input/output
signals are indicated below:
1. If an operation mode input signal other than manual mode input signals is given during the
memory mode operation, the CNC stops execution of a part program after the completion
of the block presently being executed.
This is also true during a part program execution in the tape or MDI mode.
2. If a manual mode input signal is given during the execution of a part program in the mem-
ory mode, the following occurs:
• Axis movment commands
MEM
(Input)
MDI
(Input)
JOG
(Input)
AUTO
(Input)
MAN
(Input)