Yaskawa YASNAC PC NC I/O Signal Function Manual - Manual (Page 61)

7 - 3
YASNAC PCNC I/O Signal Function Manual Chapter 7: Programming Support Functions
IMPORTANT!
1. The part program information is ignored only when the part program is executed. Accord-
ingly, this optional block delete input signal does not have influence when storing part pro-
grams into the CNC part program memory.
2. Whether the information is treated as significant information or ignored is determined by the
status of the optional block delete input signal does not have influence when storing part pro-
grams into the CNC part program memory.
Therefore, if the optional block delete input signal status should be controlled by the external
circuit using the auxiliary function, attention must be paid so that the status of the input signal
is established before the block containing the “/” code is stored into the buffer area.
3. If more than one optional block delete code is specified in one block, it is treated as follows:
Example: When BDT3 input signal is “closed”
4. For a macro program, the optional block delete function cannot be used.
7.3 Optional Block Delete Input Rewind Input Signals, and Rewinding Output Signal
(1) End of Program and Rewind Input Signals
These signals determine the processing to be taken by the CNC when the M02 or M30
command is executed.
Processing by the CNC is determined by the status of the EOP and RWD input signals
when the FIN input signal (the complete input for M02 or M30) is closed.
EDT7 input signal is “closed” From “/7” to “EOB”
EDT8 input signal is “closed” From “/8” to “EOB”
EDT9 input signal is “closed” From “/9” to “EOB”
End of Program Input Signal EOP #30410
Rewind Input Signal RWD #30411
Rewinding Output Signal RWDS #35376
Signal Information to be Ignored
/G01 /2 X____/3 Y____/4 Z____/5 F____;
Significant information insignificant information