TA Triumph-Adler DC 2325 - Manual (Page 47)

FAX Operation (Basic)
OPERATION GUIDE 3-15
3
Cancelling Direct Transmission
During direct transmission, to cancel communication during transmission,
press the Stop key on the operation panel or [Cancel] on the touch panel.
The originals that have been scanned are ejected, and the screen returns
to the send default screen. When originals remain in the document
processor, take them out.
Cancelling Transmission (Disconnection of Communication)
When you cancel sending or receiving by disconnecting the telephone line
during communication, use the following procedure.
NOTE: If the Dual FAX option is installed, disconnect the line currently
being used for communication.
1 Press the Status/
Job Cancel key.
2 Press [Device/Communication].
3 Press [Line Off] of
FAX Port 1 or FAX
Port 2 (option).
When the cancel
confirmation screen
appears, press
[Yes].
The line in
transmission is
disconnected.
Cancelling Polling or Sub Address Bulletin Board Transmissions
To cancel a polling or sub address bulletin board transmission, delete the
polling transmission original saved in the polling box. For information on
how to delete the saved original, refer to Deleting Originals in a Polling Box
on page 4-61.
30/40/50 ppm model 25 ppm model
Status
Status
Ready .
Device/
Communication
Paper /Supplies
10/10/2007 10:00
Scanner
Ready .
Printer
Not connected.
Removable Memory
Hard Disk
Not connected.
Memory Card
Storing Jobs Sending Jobs Printing Jobs
Format Remove
Line Off Manual RX
Receiving...
FAX Line 1
Log
Format Printing list
FAX Check New FAX FAX/i-FAX