TA Triumph-Adler DC 2325 - Manual (Page 80)

FAX Operation (Advanced)
4-14 OPERATION GUIDE
Remote Switch Function
You can start fax reception by operation from the connected telephone set.
This function is convenient for using this machine and a telephone set
(commercially available product) in combination installed at places distant
from each other.
To start fax reception by operation from the connected telephone set, use
the following operation.
NOTE: In order to use remote switch, it is necessary to connect the tone
signal-sending telephone set (commercially available product) to the
machine. However, even if it is a tone signal-sending telephone set, this
function may not be used satisfactorily depending on the type of
telephone set. For details, contact our agent or the store where you
purchased this machine.
How to Register Remote Switch Dial
Remote switch dial is set to 55 at the factory, but you can change the dial
number.
1 Press the System Menu key.
2 Press [FAX/i-FAX], [Next] of Reception, [Next] of FAX, and then [Change]
of Remote SW Dial.
3 Press [+]/[-] or the
numeric keys to
enter the number
you newly register.
(00 to 99)
4 Press [OK].
5 To exit from this setup, press [Close] several times until the System Menu
default screen is displayed.
Using the Remote Switch Dial
To start fax reception by operation from the connected telephone set, use
the following operation.
Status
FAX - Remote SW Dial
Set a number which a connected telephone can use
to remotely initiate a switch to FAX mode.
Use [-]/[+] or the numeric keys to enter a number.
Cancel OK
55
10/10/2007 10:00
(00-99)