TA Triumph-Adler DC 2325 - Manual (Page 64)

FAX Operation (Basic)
3-32 OPERATION GUIDE
Dialing the Same Receiving System (Redial)
Redial is a function allowing you to dial the last entered number once
again.
Automatic Redial
This function automatically redials a receiving system that does not
respond when you try to send fax.
No particular setting is required for automatic redial. Because the machine
redials repeatedly at a regular interval, you do not need to worry even
when the communication by the receiving system is prolonged.
NOTE: When using direct transmission, the machine does not
automatically redial.
You can change the number of automatic redials from between 0 and 14.
For details, refer to Retry Times on page 6-9.
You cannot send delayed transmission immediately while the machine is
waiting for redial.
Manual Redial (Recall)
Use this when the receiving system does not respond when you have tried
to send a fax. When you want to send the fax to the same receiving system,
press [Recall], and you can call the receiving system you dialed on the
destination list.
1 Press [Recall]. The
receiving system you
dialed is displayed
on the destination
list.
NOTE: When the last transmission included multi-address transmissions
and computers and e-mail destinations, they are also displayed. If
necessary, add or delete the receiving system.
2 Press the Start key. The transmission will start.
NOTE: Recall information is canceled in the following conditions.
• When you turn the power off
• When you send a next fax (new recall information is registered)
• When you log out
Status 10/10/2007 10:00
Enter Destination.
Ready to send.
Destination
Destination
Detail Address Book
FAX No.
Entry
Folder Path
Entry
E-mail
Addr Entry
Chain Detail /Edit Delete Recall
Destination Quick Setup Type of Original/
Transmission
Color/Image Advanced
Setup
No.
0
1/1
1/10
001 002 003 004 005
006 007 008 009 010
Free A OFFICE i-FAX
Addr Entry
On Hook